firelasas.blogg.se - Where to do terminal commands on a mac cheat sheet

WHERE TO DO TERMINAL COMMANDS ON A MAC CHEAT SHEET UPDATE

Config# access-list 10 permit any – allows any address.

Config# access-list 10 permit host 133.2.2.2 – specifies a specific host.

Config-if# ipx network 222 encapsulation sap – Also Novell-Ether, SNAP, ARPA on Ethernet.

Config# ipx maximum-paths 2 – Maximum equal metric paths used.

Config# ip routing – Enabled by default.

Config# ip default-network Net_Add – Gateway LAN network IP ROUTING:.

Config# ip route 0.0.0.0 0.0.0.0Next_Hop_Add – Default route.

# clear cdp counters – Clears CDP counters.

# clear counters – Clears all interface counters.

# clear interface Ethernet 0 – Clears counters on the specified interface.

Config# ip domain-name – Domain to append to end of names CLEARING COUNTERS:.

Config# ip name-server 122.22.2.2 – Location of DNS server.

Config# ip domain-lookup – Tell router to lookup domain names.

Config# ip host ROUTER_NAME INT_Address – Example: ip host lab-a 192.168.5.1.

Config# no cdp run – Turns CDP off HOST TABLE:.

Config-if# no cdp enable – Disables CDP on the interface.

Config-if# cdp enable – Enables cdp on the interface.

WHERE TO DO TERMINAL COMMANDS ON A MAC CHEAT SHEET UPDATE

Config# cdp timer 30 – Sets the update timer.The default is 60.Config# cdpholdtime 180 – Sets the time that a device remains.Config# boot system flash – Then – Config# reload CDP:.Config# boot system tftp FILENAME SERVER_IP – Example: boot system tftp 2600_ios.bin 192.168.14.2.Config# config-register 0x2102 – Boot from NVRAM BOOT SYSTEM:.

Config# config-register 0x2101 – ROM boot.Config# config-register 0x2100 – ROM Monitor Mode.# clock set hh:mm:ss dd month yyyy – Example: clock set 14:35:00 25 August 2003 CHANGING THE REGISTER: Config# description THIS IS THE SOUTH ROUTER – can be entered at the Config-if level CLOCK:.Config# banner motd # TYPE MESSAGE HERE # – # can be substituted for any character, must start and finish the message DESCRIPTIONS:.Config# terminal ipnetmask-format hexadecimal|bit-count|decimal – changes the format of subnet masks HOST NAME:.Config# terminal monitor – shows output on telnet session.Config# terminal editing – allows for enhanced editing commands.If you are unfamiliar with Cisco devices please see: Routers, Using the Cisco IOS. These commands are used on all Cisco devices running the Cisco IOS. I have had many people ask me about commands on switches and I was going to make a cheat sheet but Erik Rodriguez did such a nice job I am going to share his work Great job Erik Cisco IOS Cheat Sheet